HARDWARE MAINTENANCE

There is no special maintenance procedure for CyBro family. There are no spare parts that you can change yourself. A routine maintenance check (about every one or two months) of PLC and control system is good practice, and should include the following items: - air temperature: check the ambient air temperature in the control cabinet, so the operating temperature range of any component is not exceeded. - air filter: if the control cabinet has an air filter, clean or replace it periodically as required. - fuses or breakers: verify that all fuses and breakers are intact.

LCS controller MC-230

• 10 8A relay output module LC-10-IQ
• 8 10A relay output module LC-8-IQ
• Universal dimmable module LD-P4-IQ
• DALI module LD-D8-IQ
• DMX module LD-DMX-IQ
• Led stripe module LD-V$-IQ

• any push buttons on binary inputs of LC-10-IQ or LC-8-IQ
• Scene panel
• Touch buttons
• EnOcean wireless Wall button or Soft remote
• On wall or on ceiling long range motion sensor
• EnOcean wireless false ceiling motion sensor