Differences

This shows you the differences between two versions of the page.

--- en:3s:tof_settings [2020/06/22 10:23] – created vidb
+++ en:3s:tof_settings [2020/07/27 10:53] (current) – vidb
@@ Line 3: / Line 3: @@
 TOF sensor must be installed facing down above entrance to the area you want to count people in or out of. The counter works by detecting when a person crosses an invisible count line that has been configured in settings.
-To access these setting, type http://x.x.x.x/login in browser; x.x.x.x being the device's IP address. On the site, login is required. When inside, the Summary menu opens. Change the menu to Settings. Select the Counting sub-menu. This menu is for configuring counting functionality.
+To access these setting, type http://x.x.x.x/login in browser; x.x.x.x being the device's IP address. On the site, login is required. When inside, the Summary menu opens.
+{{:en:3s:tof1.png?1000|}}
+Change the menu to Settings. Select the Counting sub-menu. This menu is for configuring counting functionality. To enable moving the lines, enable Edit mode in the upper left corner.
+{{:en:3s:tof2.png?1000|}}
 Configure the count lines so that people are counted accurately. When positioning the lines, always ensure that there is enough ‘initialisation’ space for the counter to recognise a person and start tracking them – lines should be positioned away from the edge of the field of view.
@@ Line 9: / Line 15: @@
 To position and shape the lines:
--First enable Line Editing Mode
+|-First enable Line Editing Mode|
--Click and drag on a straight part of a line to move the whole line.
+|-Click and drag on a straight part of a line to move the whole line.|
--Click on large end or middle ‘drag’ point to move just that point.
+|-Click on large end or middle ‘drag’ point to move just that point.|
--Click on a small point on a line to create another drag point.
+|-Click on a small point on a line to create another drag point.|
--Hold CTRL and click on a drag point to delete it.
+|-Hold CTRL and click on a drag point to delete it.|
--In standard door counting applications it is recommended to position the lines around the door in a U or arc shape. To avoid counting ‘cross traffic’ ensure that the correct count mode is selected.
+|-In standard door counting applications it is recommended to position the lines around the door in a U or arc shape. To avoid counting ‘cross traffic’ ensure that the correct count mode is selected.|
 In most cases lines configured for IN and OUT should be positioned in the same position and configuration with only the direction reversed.
@@ Line 20: / Line 26: @@
 Advanced features of TOF sensor allow:
--Staff detection. Detection is passive, all employees need to do is wear a special lanyard.
+|-Staff detection. Detection is passive, all employees need to do is wear a special lanyard.|
--Staff call and attend. Automated alerts for staff members can be raised when customers are detected waiting.
+|-Staff call and attend. Automated alerts for staff members can be raised when customers are detected waiting.|
--Dwell time monitoring. The length of time customers spend in defined zones can be measured and reported.
+|-Dwell time monitoring. The length of time customers spend in defined zones can be measured and reported.|
--Height measurement and filtering. Height is measured accurately to +/- 2cm and can be used to set filters, for example exclude children and just count adults.
+|-Height measurement and filtering. Height is measured accurately to +/- 2cm and can be used to set filters, for example exclude children and just count adults.|