Differences

This shows you the differences between two versions of the page.

--- en:hems:methods_resources:commissioning [2021/01/31 18:50] – [Micro smart plug, smart plug and relay switch-1 channel] saso_santelj
+++ en:hems:methods_resources:commissioning [2021/02/02 10:50] (current) – [Configuration] saso_santelj
@@ Line 15: / Line 15: @@
-Install and run {{ :hiq_energy:hems:methods_resources:hems_configurator_v1.1.1.exe|HEMS Configurator}} on your PC.
+Install and run {{ :hiq_energy:hems:methods_resources:hems_configurator_v1.1.2.exe|HEMS Configurator}} on your PC.
 Go to the "**settings**" page.
@@ Line 120: / Line 120: @@
   * In the HEMS Configurator press **"del"** button next to the consumer connected to the channel module you want to remove
-  * After a few seconds, delete the channel of a module should appear as the "new device"
+  * After a few seconds, deleted channel of a module should appear as a "new device"
-  * If desired, the module can be removing if delete another channel or the deleted channel can be assigned to another consumer
+  * We can remove the module by deleting the second channel or the deleted channel can be assigned to another consumer
 === Setting repeater level ===
-When enabling repeater mode, the wireless module can repeater a message not addressed to him, and increase range by creating network gride between all wireless devices.
+When enabling repeater mode, the wireless module can repeat a message not addressed to him, and increase range by creating network grid between all wireless devices.
 The repeater can be configured to level 0 (off), level 1 (one hop), or level 2 (two hops):
@@ Line 168: / Line 168: @@
 ==== Backup / restore to PC ====
-HEMS Configurator allows you to backup and restores all parameters to pc.
+HEMS Configurator allows you to backup and restores all parameters to PC.
 ¹ Only for the first power plant