Differences

This shows you the differences between two versions of the page.

--- en:hems_v1_2_0:commissioning [2021/11/17 11:16] – [IO mux] gdzampo
+++ en:hems_v1_2_0:commissioning [2021/11/19 14:18] (current) – [Three-phase power-sensor] gdzampo
@@ Line 70: / Line 70: @@
   * After a few seconds, the sensor should appear as the "new device"
   * If desired, the sensor can be removed or it can be assigned to another device
+<WRAP pagebreak></WRAP>
 ==== Power plant connection ====
@@ Line 190: / Line 190: @@
 ==== IO mux ====
-IO mux page within [[en:hems_v1_2_0:software|HEMS configurator]] allows setting of input/output types for ports on controller.
+IO mux page within [[en:hems_v1_2_0:software|HEMS configurator]] allows setting of input/output types for ports on controller:
-  * using HEMS configurator on settings page, define analog output for consumer 1,
+  * e.g. if it is set QX2 -> Router reset, it means that when conditions are met (for reset), QX2 port will change state to turn OFF router,
-  * on IO MUX page define IO14 and/or IO15 port for Analog/PWM output,
+  * or if it is set QX2 -> Digital-2, it means that digital2 (consumer 2) is assigned to QX2 and enables switching ON/OFF on it,
-  * on home screen define analog value 0-100% (long-press) for consumer1 and turn it ON/OFF with short-press.
+  * for input ports IX0,IX1 and IX2 it is possible to set toggle and enable functionality ([[en:hems_v1_2_0:wiring|HEMS wiring]]). it means that dedicated consumer will be directly managed (ON/OFF) by input signal on IX0,IX1 or IX2.
-**Note**: if it is set **analog** for consumer without assigned power sensor, it is possible to define **P nominal** power instead. It represents fixed power of consumer and while in operating mode HEMS calculates consumed energy.
 ==== Permanent memory ====