User Tools

Site Tools


en:hems_v1_2_0:software

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
en:hems_v1_2_0:software [2021/11/16 14:06] – [io mux] gdzampoen:hems_v1_2_0:software [2021/11/30 09:16] (current) – [limiter] gdzampo
Line 262: Line 262:
 | Voltage for each phase                                                              ||| | Voltage for each phase                                                              |||
 ^ 5. Phase order                                                                      ||| ^ 5. Phase order                                                                      |||
-Firstly set correct phase order for grid power sensor and then set for other powers sensors/devices. NOTE: changing grid phase order will NOT apply to phase order of other devices!       |||+First set correct phase order for grid power sensor and then set for other power sensors/devices. NOTE: changing grid phase order will NOT apply to phase order of other connected devices!       |||
 ^ 6. Current limit                                                                    ||| ^ 6. Current limit                                                                    |||
 | Current limit threshold for main grid fuse                                          ||| | Current limit threshold for main grid fuse                                          |||
Line 277: Line 277:
  
 <WRAP clear></WRAP> <WRAP clear></WRAP>
- 
-<WRAP pagebreak></WRAP> 
  
 ===== ev fleet===== ===== ev fleet=====
Line 315: Line 313:
 <WRAP clear></WRAP> <WRAP clear></WRAP>
  
-<WRAP pagebreak></WRAP> 
  
 ===== io mux ===== ===== io mux =====
Line 342: Line 339:
  
 <WRAP clear></WRAP> <WRAP clear></WRAP>
- 
 <WRAP pagebreak></WRAP> <WRAP pagebreak></WRAP>
  
  
 ===== settings ===== ===== settings =====
- 
-Easy and intuitive system setup. 
- 
-<WRAP column 650px> 
  
 {{:hiq_energy:hems_v1_2_0:settings_1.png?direct&800|}} {{:hiq_energy:hems_v1_2_0:settings_1.png?direct&800|}}
  
-</WRAP> 
  
 <WRAP column 650px> <WRAP column 650px>
Line 369: Line 360:
 |  Virtual grid PS     | [] enable  | Check if system is without main grid power meter. Energy, power and currents are calculated from other power meters.                        | |  Virtual grid PS     | [] enable  | Check if system is without main grid power meter. Energy, power and currents are calculated from other power meters.                        |
 ^ 2. Modbus cycle time                                                                                                                                                 ||| ^ 2. Modbus cycle time                                                                                                                                                 |||
-|  Modbus cycle time   Time in ms for modbus communication to complete reading of all connected devices.                                                                       ||+|  Modbus cycle time   Grid power sensor refresh time in ms                                                                             ||
 ^ 3. Sources and Consumers settings table                                                                                                                                       ||| ^ 3. Sources and Consumers settings table                                                                                                                                       |||
 |      SOURCES             | Source name                                                                                                                                         || |      SOURCES             | Source name                                                                                                                                         ||
en/hems_v1_2_0/software.1637071579.txt.gz · Last modified: 2021/11/16 14:06 by gdzampo