User Tools

Site Tools

Trace: • methods • sidebar • acess_control_camera • hardware • usb_modem_for_iot-l2-2 • wiring • tvoc_temperature_and_humidity_sensor • introduction
en:hems_v1_2_0:software

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
en:hems_v1_2_0:software [2021/11/23 08:35] – [settings] gdzampoen:hems_v1_2_0:software [2021/11/30 09:16] (current) – [limiter] gdzampo
Line 262: Line 262:
 | Voltage for each phase                                                              ||| | Voltage for each phase                                                              |||
 ^ 5. Phase order                                                                      ||| ^ 5. Phase order                                                                      |||
-| Firstly set correct phase order for grid power sensor and then set for other powers sensors/devices. NOTE: changing grid phase order will NOT apply to phase order of other devices!       |||+| First set correct phase order for grid power sensor and then set for other power sensors/devices. NOTE: changing grid phase order will NOT apply to phase order of other connected devices!       |||
 ^ 6. Current limit                                                                    ||| ^ 6. Current limit                                                                    |||
 | Current limit threshold for main grid fuse                                          ||| | Current limit threshold for main grid fuse                                          |||
en/hems_v1_2_0/software.1637656531.txt.gz · Last modified: 2021/11/23 08:35 by gdzampo