Differences

This shows you the differences between two versions of the page.

--- en:hiq_hw:rdx_charger [2023/01/23 10:05] – gdzampo
+++ en:hiq_hw:rdx_charger [2023/01/30 15:01] (current) – removed gdzampo
@@ Line 1: / Line 1: @@
-====== RDX Charger (Robotina Dynamic Charger) ======
-<WRAP column 400px>
-{{hiq_hardware:rdx_charger_wiki.png}}
-</WRAP>
-<WRAP column 550px>
-|< 100% 80% 20% >|
-| Description ^ Order Code                                              |
-| RDX Charger with type 2 cable and RFID card reader  ^ RDX-RF                                            |
-| RDX Charger with type 2 cable, RFID reader and residual current device ^ RDX-RF-R                                              |
-| RDX Charger with type 2 cable, RFID reader and IOT Linker^RDX-RF-I                                             |
-| RDX Charger with type 2 cable, RFID reader, residual current device and IOT linker^RDX-RF-RI                                  |
-| RDX Charger with type 2 cable and QR code reader  ^ RDX-QR                                            |
-| RDX Charger with type 2 cable, QR code reader and residual current device ^ RDX-QR-R                                              |
-| RDX Charger with type 2 cable, QR code reader and IOT Linker^RDX-QR-I                                             |
-| RDX Charger with type 2 cable, QR code reader, residual current device and IOT linker^RDX-QR-RI                                  |
-</WRAP>
-<WRAP clear></WRAP>
-===== Features =====
-  * **Up to 22kW of charging power**
-  * **Modern design with IP54 & IK10 standard**
-  * **Suitable for indoor and outdoor use**
-  * **Coloured LED light indicates charging status**
-  * **Easy operability with one button on housing**
-  * **Monitor & control on application**
-  * **Compatible with 3rd party software**
-  * **Secure charger with remote locking option**
-  * **Save by charging (economy charging) during off-peak hours**
-  * **Charge with surplus energy**
-  * **Priority charging at the highest possible power**
-  * **Dynamic load balancing keeps consumption power below max allowed (protect grid fuse/s)**
-  * **Manage charging of electric vehicles (EV fleet)**
-  * **Remote control of key consumers (heat pump, battery storage system...)**
-  * **6mA DC residual current, overvoltage and undervoltage protection**
-  * **RFID or QR access control**
-  * **Long range wireless power meters for installation without cabling**
-  * **Fully compliant with IEC 61851**
-<WRAP pagebreak></WRAP>
- ===== Technical specifications =====
-| Nominal voltage 	    |     1x230Vac 50/60Hz, 3x230/400Vac 50/60Hz|
-| Maximum current |             1x32A, 3x32A|
-| Maximum charging power |             22kW|
-| Connector        	  |  Type2, 5m cable|
-| Network connection         |  Ethernet 100M RJ45|
-| Ingress protection   |            IP54|
-| Impact resistance 	    |         IK10|
-| Operating temperature	      |           -20°C to +45°C|
-| Storage temperature  |                       -40°C to + 70°C|
-| Charging pilot negative  |                     1mA, 20ms reaction time|
-| Residual direct current  |                     6mA, 200ms reaction time|
-| Standards   |                      IEC 61851|
-===== Dimensions =====
-{{hiq_hardware:rdx_charger_dimensions.png}}
-===== Cable holder mounting options =====
-{{hiq_energy:rdx_charger:montaza_6.png}}\\
-===== Accessories =====
-| **Description** 	    |     **Order Code**|
-| Wireless external single-phase Power sensor kit|            **WPM1-E-D**|
-| Wireless external three-phase Power sensor kit |             **WPM3-E-D**|
-| External single-phase Power sensor|            **PM1-E-D**|
-| External three-phase Power sensor|             **PM3-E-D**|
-| Wireless Modbus bridge |  **WM-1**|
-| Wireless relay, to control other loads in the building |  **WR-1**|
-| Protective roof      |  **RDX-PR**|
-| Freestanding set   |            **RDX-FS**|
-| 4G LTE modem for IOT linker **This option is only possible for RDX Charger models that already have an integrated IOT linker**|            **IOT-L2-W**|