Differences

This shows you the differences between two versions of the page.

--- en:hiq_hw:wr-1 [2022/11/29 14:44] – [Technical specification] gdzampo
+++ en:hiq_hw:wr-1 [2022/12/02 14:33] (current) – [Terminals and wiring] gdzampo
@@ Line 24: / Line 24: @@
 ===== Installation and mounting =====
-  * :!: Carefully open WR-1 module and configure serial communication with jumpers. (Default configuration is 9600bps, 8N1 with normal timeout)
+  * :!: Carefully open WR-1 module and configure address with jumpers. (Default address is 200)
   * :!: Place WR-1 module at least 10cm from other objects. Installation is not recommended inside metal cabinets.
-  * Connect RS485 terminals to WR-1 RS485 terminals
+  * Connect relay terminals
-    * A - A
-    * B - B
-    * C - GND
   * Connect to 230V power supply
   * Configure radio pairing
@@ Line 72: / Line 69: @@
 |Output power            |                           25mW |
 |Operating range         |  3..300m with optical visibility|
-===== Terminals and wiring =====
-| To power sensor ^ A | RS485 bus  |
+===== Modbus address setting =====
-| :::            ^ B | :::        |
+Change is applied right away, no reset needed.
-| :::            ^ C | :::        |
-| To power supply ^ L| 230V AC |
-| :::             ^ N| :::     |
-{{ hiq_hardware:wm1_wiring.png?nolink&0x200  }}
+{{ hiq_hardware:WR-1_address_settings.png?nolink&0x500  }}
-<WRAP pagebreak></WRAP>
-===== Serial configuration and timeout =====
-  * Available baudrates 2400, 9600, 19200, 38400 bps
-  * Data bits and parity 8N1, 7E1, 8E1, 8N2
-  * :!: Max 64 bytes per transmition
-  * Integrated 240 Ohm termination resistor
-{{ hiq_hardware:wm1_serial.png?nolink&0x500  }}
 ===== Radio pairing configuration =====