en:ms_main:hiq_lighting:introduction
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
en:ms_main:hiq_lighting:introduction [2020/04/18 08:54] – marjan_strnad | en:ms_main:hiq_lighting:introduction [2020/04/25 15:53] (current) – removed marjan_strnad | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== HIQ Lighting Control – HIQ LCS Introduction ====== | ||
- | |||
- | HIQ LCS is a system of integrated devices and software that is targeted for lighting automation. | ||
- | The primary function is control and management of any lights – on/off, dimmable, LED RGB, LED stripes using local wired or wireless push or touch buttons, Wi-Fi tablets, Mobile phones or BMS/SCADA monitoring and control. Lights can be controlled by scenarios, scheduled, by motion sensors using direct relay modules, DALI, DSI or PWM/Triac dimmable and LED stripes. Although the basic concept of HIQ LCS is simple, the possibility to extend current capabilities or add new is unlimited. | ||
- | |||
- | ===== HEMS Controller ===== | ||
- | |||
- | It consists of an HEMS master controller ([[en: | ||
- | |||
- | <WRAP pagebreak></ | ||
- | |||
- | ===== Power sensors ===== | ||
- | |||
- | The measurement of electrical power and energy of all energy sources and main electrical consumers is provided by single-phase ([[en: | ||
- | * **1 grid** power sensor | ||
- | * up to **3** sensors for local power **plants** (PV, Wind, Cogeneration, | ||
- | * up to **2** local **storage** systems (home battery) | ||
- | * up to **4** managed **consumers** (electrical heating, electrical water heater, washing machine, tumble dryer, ...) | ||
- | |||
- | ===== Power relays ===== | ||
- | |||
- | Are used for control of managed consumers. Power relays are toggling power supply or enabling signal for the operation of the device. They are controlled directly from HEMS master controller [[en: | ||
- | |||
- | ===== Push buttons ===== | ||
- | |||
- | Are used for manual control of managed devices. Push buttons are directly wired to HEMS master controller [[en: | ||
- | |||
- | {{: | ||
- | |||
- | |||
en/ms_main/hiq_lighting/introduction.1587200092.txt.gz · Last modified: 2020/04/18 08:54 by marjan_strnad