Differences

This shows you the differences between two versions of the page.

--- en:robotina_charger:commissioning:pv_inverter [2022/12/09 13:57] – [EVSE and PV inverter connection] gdzampo
+++ en:robotina_charger:commissioning:pv_inverter [2022/12/09 14:59] (current) – [EVSE and PV inverter connection] gdzampo
@@ Line 25: / Line 25: @@
 To add inverter on HEMS configurator:
   *   on settings page inside source table, select SolarEdge inverter. Please see [[en:robotina_charger:software#settings|]]
-  *   on io mux page define IP address for inverter. Please see [[en:robotina_charger:software#io mux|]]
+  *   on io mux page set IP address for inverter. Please see [[en:robotina_charger:software#io_mux|]]
 To setup Modbus TCP on Inverter using SetApp:
   *   Select Site Communication menu
      * RS485-1 -> Protocol -> SunSpec (Non-SE Logger)
-     * RS485-1 -> Device ID, and enter the number 1.
+     * RS485-1 -> Device ID, and enter the number 1
-     * Select Modbus TCP and set to Enable.
+     * Modbus TCP and set to Enable
-     * To modify the *TCP port, select Port, set the port number to 502.
+     * set TCP port to 502
-     *
+**Note**:\\ The TCP server idle time is 2 minutes. In order to leave the connection open, the request should be made within 2 minutes.\\ It is important to follow rules above, firstly to set HEMS configurator following Inverter setup due to 2 minutes time frame.
-*TCP port is 1502 by default.