Differences

This shows you the differences between two versions of the page.

--- en:robotina_charger:commissioning [2022/12/09 09:00] – [Configuration] gdzampo
+++ en:robotina_charger:commissioning [2022/12/22 09:27] (current) – removed gdzampo
@@ Line 1: / Line 1: @@
-====== Commissioning ======
-Strictly follow [[en:robotina_charger:commissioning:safety|Safety instructions]]!
-===== Mounting =====
-Mount Robotina charger (EVSE), PM1-E-D & PM3-E-D power sensors as well as wireless modbus WM-1 & relay WR-1 to a suitable place. For more details, please read here [[en:robotina_charger:Hardware]].
-===== Wiring =====
-Connect EVSE to the home LAN. Wire WM-1 module with power sensor and WR-1 relay with device.
-===== Configuration=====
-Install and run [[en:robotina_charger:software|Robotina Charger]] on your PC.
-Go to the "**settings**" page.
-With the "**autodetect**" button, the application will locate the controller in the local network.
-Enter **names**, select **icons** for all sources and consumers.