Differences

This shows you the differences between two versions of the page.

--- en:robotina_charger:commissioning [2022/12/14 14:01] – [Wiring] gdzampo
+++ en:robotina_charger:commissioning [2022/12/22 09:27] (current) – removed gdzampo
@@ Line 1: / Line 1: @@
-===== Commissioning =====
-Strictly follow [[en:robotina_charger:commissioning:safety|Safety instructions]]!
-===== Mounting =====
-Mount Robotina charger (EVSE), [[en:hiq_hw:pm1-e-d|PM1-E-D]] & [[en:hiq_hw:pm3-e-d|PM3-E-D]] power sensor as well as [[en:hiq_hw:wm-1|WM-1]] & [[en:hiq_hw:wm-1|WR-1]] to a suitable place. For more details, please read [[en:robotina_charger:Hardware]].
-===== Wiring =====
-Connect EVSE to the home LAN. Wire WM-1 module with power sensor and WR-1 relay with device (e.g. heat pump, el. radiator). For more details, please read [[en:robotina_charger:Wiring]].
-===== Configuration=====
-Install and run [[en:robotina_charger:software|Robotina Charger]] on your PC. With the "**autodetect**" button, the application will locate EVSE in the local network. Enter **names**, select **icons** for all sources and consumers.\\
-. How to add or delete power sensor please see [[en:robotina_charger:commissioning:power_sensor|Power Sensor]]\\
-. How to set PV SolarEdge inverter please see [[en:robotina_charger:commissioning:pv_inverter|PV Inverter]]\\
-. How to set WM-1 and WR-1 please see [[en:robotina_charger:commissioning:wr1_wm1|Wireless WR1 & WM1]]\\
-. How to set heat pump please see [[en:robotina_charger:commissioning:heat_pump|Heat Pump]]