✎ en:access-iq:configurator []

You've loaded an old revision of the document! If you save it, you will create a new version with this data.

====== HIQ Access configurator ======

===== Codes management =====

</WRAP>

</WRAP>
<WRAP clear></WRAP>

===== Access events list =====

</WRAP>

</WRAP>
<WRAP clear></WRAP>

===== Access settings =====

|< 100% 150px >|
^  Code readers settings                                                                                ||
^ Code                     | Code read by reader, click for manual entry                                 |
^ R-ID                     | Reader ID; link reader to access point ("show" or lock)                     |
^ Type                     | Access point type (- / Master ADD / Master All), click to toggle            |
^ State                    | State of access point.                                                      |
^  Access points settings                                                                               ||
^ AP-ID                    | Access point ID; link to code rights                                        |
^ Show: R-ID               | Link to reader ID; link to the reader for signaling the access point        |
^ Show: OUT                | Show output (click to toggle)                                               |
^ Show: Tout               | Show time-out                                                               |
^ Lock: R-ID               | Link to reader ID; link to the reader for unlocking the access point        |
^ Lock: OUT                | Lock output (click to toggle)                                               |
^ Lock: Tout               | Lock time-out                                                               |
^  General settings                                                                                     ||
^ Master code              | Master code for auxiliary code management                                   |
^ [ Parameters init ]      | Click to initialize all parameters to factory defaults                      |
^ [ Parameters save ]      | Click to save all parameters to permanent memory                            |
^ [ Parameters read ]      | Click to read all parameters from permanent memory                          |
^ Access HW modules        | Detected modules are displayed unmasked.                                    |
^ [ Autodetect ]           | Press to find HIQ Access controller in local network.                       |

</WRAP>

</WRAP>
<WRAP clear></WRAP>

Edit summary

Note: By editing this page you agree to license your content under the following license: CC Attribution-Share Alike 4.0 International