✎ en:hiq_hw:wr-1 []

You've loaded an old revision of the document! If you save it, you will create a new version with this data.

====== Wireless Modbus Relay ======

**Wireless Modbus Relay**

</WRAP>

===== Applications =====

* Remote controlled relay. Act as modbus RTU slave. Optimal for long range, no hopping.

</WRAP>

===== Installation and mounting =====
  * :!: Carefully open WR-1 module and configure serial communication with jumpers. (Default configuration is 9600bps, 8N1 with normal timeout)
  * :!: Place WR-1 module at least 10cm from other objects. Installation is not recommended inside metal cabinets.
  * Connect RS485 terminals to WR-1 RS485 terminals
    * A - A
    * B - B
    * C - GND
  * Connect to 230V power supply
  * Configure radio pairing

===== Features =====

* remote controlled relay
  * act as modbus RTU slave
  * very long range, no hopping
  * up to 8 relays per network
  * protected private connection
  * multiple addressable groups

===== Technical specification =====

===== Terminals and wiring =====

| To power sensor ^ A | RS485 bus  |
| :::            ^ B | :::        |
| :::            ^ C | :::        |
| To power supply ^ L| 230V AC |
| :::             ^ N| :::     |

===== Serial configuration and timeout =====
  * Available baudrates 2400, 9600, 19200, 38400 bps
  * Data bits and parity 8N1, 7E1, 8E1, 8N2
  * :!: Max 64 bytes per transmition
  * Integrated 240 Ohm termination resistor

===== Radio pairing configuration =====

==== Create new secure group ====
  
  * turn on all devices as the same time
  * within 10 seconds, while RF LED is blinking, press and hold button on one of the devices
  * after a second, the new address is randomly generated and sent to all devices. RF LED will blink 3 times to confirm the new address.

==== Add new device to the group ====
  
  * turn on the device
  * within 10 seconds, press and hold button on one of the existing devices
  * after a second, the existing group address is sent to the new device. RF LED will blink 3 times to confirm the address is sent.

==== Examples ====

===== Connection check =====
  * press the button shortly \\
With each press of the button, the relay will
switch on/off. Other devices are not affected.

===== Factory reset =====
  * Hold button and turn the device ON
  * RF led will blink twice. Group address is now reset to default. 
  * Other devices will not be affected.

Edit summary

Note: By editing this page you agree to license your content under the following license: CC Attribution-Share Alike 4.0 International