✎ en:robotina_charger:commissioning:power_sensor []

You've loaded an old revision of the document! If you save it, you will create a new version with this data.

==== Add power sensor ====

<WRAP column 450px>
Default address on all power sensor is 149.\\ 
Available addresses for sensors are listed in table.\\
**Note**: adding is supported one by one.   
</WRAP>

<WRAP column 270px>
|< 100% 40% 60% >|
^ Address ^ Power sensor position|
| 150 | Grid |
| 154,155,156 | PV |
| 157,158 | Battery storage |
| 161..167 | consumer |
</WRAP>

=== One-phase sensor PM1-E-D ===

*   Wire it to communication bus
  *   In HEMS Configurator power sensor should appear as a "new device"
  *   Press and hold the push-button on the power sensor until it appears **-SEt-** on display
  *   In HEMS Configurator click on the **add** button next to the source or consumer that the sensor is measuring
  *   Connect communication bus to the next power-sensor and repeat procedure

=== Three-phase sensor PM3-E-D ===

* **Connect** communication bus (to only one power-sensor)
  * In HEMS Configurator power-sensor should appear as a "new device"
  * Click on the **" add"** button next to the source or consumer that the sensor is measuring
  * Connect communication bus to the next power-sensor and repeat procedure

**Note**: It is possible to set address manually - before adding power sensor to communication bus.Allowed addresses are 150,154,161-167.

=== Without grid power sensor ===

*   **Virtual grid PS** is an option if no grid meter is used. Power, current and energy will be calculated from other power sensors.

==== Power-sensor removing ====

=== One-phase sensors PM1-E-D ===

* Make sure the "new device" is empty
  * Press the button on power-sensor until **-Set-** appears on the display
  * In HEMS Configurator press **"del"** button next to the sensor
  * After a few seconds, the sensor should appear as the "new device"
  * If desired, the sensor can be removed or it can be assigned to another device

=== Three-phase power-sensor ===

* Make sure the "new device" is empty
  * In HEMS Configurator press **"del"** button next to the sensor
  * After a few seconds, the sensor should appear as the "new device"
  * If desired, the sensor can be removed or it can be assigned to another device
<WRAP pagebreak></WRAP>

Edit summary

Note: By editing this page you agree to license your content under the following license: CC Attribution-Share Alike 4.0 International