Page locked

This page is currently locked for editing by another user. You have to wait until this user finishes editing or the lock expires.

Currently locked by: 216.73.216.98,10.0.0.202
Lock expires at: 2025/06/06 17:32 (11 min)

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

==== Power sensor management ====

<WRAP column 450px>
Default address on all power sensor is 149.\\ 
Available addresses for sensors are listed in table.\\
\\

</WRAP>

<WRAP column 270px>
|< 100% 40% 60% >|
^ Address ^ Power sensor position|
| 150 | Grid |
| 154,155,156 | PV |
| 157,158 | Battery storage |
| 161..167 | Consumer |
</WRAP>
<WRAP clear></WRAP>

Add power sensor procedure:

  *   wire it to communication bus,
  *   only for PM1-E-D: press and hold the push-button on the power sensor until it appears **-SEt-** on display,
  *   it should appear in configurator as new device, click on button **add** next to the source or consumer where sensor should be assigned,
  *   repeat procedure for next.

**Note 1**: adding of power sensor is supported one by one.\\   
**Note 2**: For PM3-E-D is possible to set address manually according to table, before adding it to communication bus.

=== Without grid power sensor ===

  *   **Virtual grid PS** is an option if no grid meter is used. Power, current and energy will be calculated from other power sensors.

==== Delete power sensor ====

=== One-phase sensors PM1-E-D ===

  * Make sure the "new device" is empty
  * Press the button on power-sensor until **-Set-** appears on the display
  * In HEMS Configurator press **"del"** button next to the sensor
  * After a few seconds, the sensor should appear as the "new device"
  * If desired, the sensor can be removed or it can be assigned to another device

=== Three-phase power-sensor ===

  * Make sure the "new device" is empty
  * In HEMS Configurator press **"del"** button next to the sensor
  * After a few seconds, the sensor should appear as the "new device"
  * If desired, the sensor can be removed or it can be assigned to another device
<WRAP pagebreak></WRAP>