✎ en:robotina_charger:commissioning:safety []

You've loaded an old revision of the document! If you save it, you will create a new version with this data.

====== SAFETY INSTRUCTIONS ======

Use the following safety guidelines to ensure your own personal safety and to protect your equipment and working environment from potential damage.

**NOTICE**: All applicable local and national codes that regulate the installation and operation of the equipment must be strictly followed.

**NOTICE**: Installation and electrical connection of the equipment must be carried out by qualified and authorized personnel.

----

Notices which require special attention are highlighted with following symbols:
  * {{:en:hems:methods_resources:warning.png?nolink|}} **WARNING** - which indicates that death, severe personal injury or substantial property damage can result if proper precautions are not taken.
  * {{:en:hems:methods_resources:warning.png?nolink|}} **CAUTION** - which indicates that minor to medium personal injury or property damage can result if proper precautions are not taken.

----

This product can only function correctly if it is transported, stored, set up and installed correctly, and operated and maintained as recommended according to manufacturer’s instructions.

{{:en:hems:methods_resources:warning.png?nolink|}} **WARNING**: Failure to comply with manufacturer’s safety and installation instructions or applicable codes and standards can result in damage to equipment or serious injury to personnel.

{{:en:hems:methods_resources:warning.png?nolink|}} **WARNING**: Before installing, servicing or repairing electrical equipment power source must be disconnected.

{{:en:hems:methods_resources:warning.png?nolink|}} **CAUTION**: Don’t try to open the device, any interference or change may impact device’s properties and significantly affect safety.

* The device must be installed inside electrical enclosure where it cannot endanger people or environment.
  * During operation, device must not be exposed to high temperature, high humidity, excessive dust, corrosive gases, vibration or shock.
  * All connected wires must comply with manufacturer's specifications.
  * For installation use only tools and equipment with non-conducting handles.
  * Sufficient ventilation space has to be assured around device for proper operation.
  * The manufacturer does not undertake any liability for material or personal damage resulting from use or handling which is not in accordance with the manufacturer's safety instructions.

Edit summary

Note: By editing this page you agree to license your content under the following license: CC Attribution-Share Alike 4.0 International