en:hiq_hw:rdx_charger
This is an old revision of the document!
Table of Contents
RDX Charger (Robotina Dynamic Charger)
| Description | Order Code |
|---|---|
| RDX Charger with type 2 cable and RFID card reader | RDX-RF |
| RDX Charger with type 2 cable, RFID reader and RCD AC | RDX-RF-R |
| RDX Charger with type 2 cable, RFID reader and IOT Linker | RDX-RF-I |
| RDX Charger with type 2 cable, RFID reader, RCD AC and IOT linker | RDX-RF-RI |
| RDX Charger with type 2 cable and QR code reader | RDX-QR |
| RDX Charger with type 2 cable, QR code reader and RCD AC | RDX-QR-R |
| RDX Charger with type 2 cable, QR code reader and IOT Linker | RDX-QR-I |
| RDX Charger with type 2 cable, QR code reader, RCD AC and IOT linker | RDX-QR-RI |
Features
- Up to 22kW of charging power
- Modern design with IP54 & IK10 standard
- Suitable for indoor and outdoor use
- Coloured LED light indicates charging status
- Easy operability with one button on housing
- Monitor & control on application
- Compatible with 3rd party software
- Secure charger with remote locking option
- Save by charging (economy charging) during off-peak hours
- Charge with surplus energy
- Priority charging at the highest possible power
- Dynamic load balancing keeps consumption power below max allowed (protect grid fuse/s)
- Manage charging of electric vehicles (EV fleet)
- Remote control of key consumers (heat pump, battery storage system…)
- 6mA DC residual current, overvoltage and undervoltage protection
- 30mA AC residual current
- RFID or QR access control
- Long range wireless power meters for installation without cabling
- Fully compliant with IEC 61851
Technical specifications
| Nominal voltage | 1x230Vac 50/60Hz, 3×230/400Vac 50/60Hz |
| Maximum current | 1x32A, 3x32A |
| Maximum charging power | 22kW |
| Connector | Type2, 5m cable |
| Network connection | Ethernet 100M RJ45 |
| 4G LTE (option) | |
| Ingress protection | IP54 |
| Impact resistance | IK10 |
| Operating temperature | -20°C to +60°C |
| Storage temperature | -40°C to + 70°C |
| RCD (residual-current device) | DC, 6mA |
| AC, 30mA (option) | |
| Standards | IEC 61851 |
Dimensions
Cable holder mounting options
Accessories
| Description | Order Code |
| Wireless external single-phase Power sensor kit | WPM1-E-D |
| Wireless external three-phase Power sensor kit | WPM3-E-D |
| External single-phase Power sensor | PM1-E-D |
| External three-phase Power sensor | PM3-E-D |
| Wireless Modbus bridge | WM-1 |
| Wireless relay, to control other loads in the building | WR-1 |
| Protective roof | RDX-PR |
| Freestanding set | RDX-FS |
| 4G LTE modem for IOT linker This option is only possible for RDX Charger models that already have an integrated IOT linker | IOT-L2-W |
en/hiq_hw/rdx_charger.1674572483.txt.gz · Last modified: by saso_santelj · Currently locked by: 216.73.216.22,10.0.0.202