en:robotina_charger:commissioning
This is an old revision of the document!
Table of Contents
Commissioning
Strictly follow Safety instructions!
Mounting
Mount Robotina charger (EVSE), PM1-E-D & PM3-E-D power sensors as well as wireless modbus WM-1 & relay WR-1 to a suitable place. For more details, please read here Hardware.
Wiring
Connect EVSE to the home LAN. Wire WM-1 module with power sensor and WR-1 relay with device.
Configuration
Install and run Robotina Charger on your PC.
Go to the “settings” page.
With the “autodetect” button, the application will locate the controller in the local network.
Enter names, select icons for all sources and consumers.
en/robotina_charger/commissioning.1670576429.txt.gz · Last modified: by gdzampo