Differences

This shows you the differences between two versions of the page.

--- en:goflex_hems:methods_resources:commissioning [2018/10/05 13:49] – ↷ Links adapted because of a move operation goran.kocjancic
+++ en:goflex_hems:methods_resources:commissioning [2019/08/14 10:49] (current) – ↷ Links adapted because of a move operation goran.kocjancic
@@ Line 3: / Line 3: @@
 ===== Control system =====
-HEMS controller [[en:goflex_hems:hardware:hc-iq-hems|HC-IQ-HEMS]] and all communication interfaces are supplied with preinstalled firmware.
+HEMS controller [[en:hiq_hw:hc-iq-hems|HC-IQ-HEMS]] and all communication interfaces are supplied with preinstalled firmware.
 For system configuration use [[en:goflex_hems:software|HIQ HEMS Configurator]] .
@@ Line 12: / Line 12: @@
   - In **HIQ HEMS Configurator** go to **settings** page. New power-meter should be detected (Address and Type should be displayed).
   - Long-press button on power meter until **-SET-** is displayed.
-  - Press **New address** and enter new address according following table.
+  - Press **New address** and enter new address according to following table.
 |<20% 60% >|
@@ Line 45: / Line 45: @@
   - **Reset device**:
-    * power off wireless device for few seconds.
+    * power off wireless device for a few seconds.
-    * After powering on wait for few seconds for device to boot on.
+    * After powering on wait for a few seconds for device to boot on.
     * Press and hold button, LED indicator will go **off**, then **green** and at the end **red**.
     * Release button.