User Tools

Site Tools

Trace:
en:goflex_hems:methods_resources:commissioning

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
en:goflex_hems:methods_resources:commissioning [2018/11/30 11:47] – [Remove device] saso_santeljen:goflex_hems:methods_resources:commissioning [2019/08/14 10:49] (current) – ↷ Links adapted because of a move operation goran.kocjancic
Line 3: Line 3:
 ===== Control system ===== ===== Control system =====
  
-HEMS controller [[en:goflex_hems:hardware:hc-iq-hems|HC-IQ-HEMS]] and all communication interfaces are supplied with preinstalled firmware.+HEMS controller [[en:hiq_hw:hc-iq-hems|HC-IQ-HEMS]] and all communication interfaces are supplied with preinstalled firmware.
  
 For system configuration use [[en:goflex_hems:software|HIQ HEMS Configurator]] . For system configuration use [[en:goflex_hems:software|HIQ HEMS Configurator]] .
Line 46: Line 46:
   - **Reset device**:    - **Reset device**: 
     * power off wireless device for a few seconds.      * power off wireless device for a few seconds. 
-    * After powering on wait for few seconds for device to boot on. +    * After powering on wait for a few seconds for device to boot on. 
     * Press and hold button, LED indicator will go **off**, then **green** and at the end **red**.      * Press and hold button, LED indicator will go **off**, then **green** and at the end **red**. 
     * Release button.     * Release button.
en/goflex_hems/methods_resources/commissioning.1543578454.txt.gz · Last modified: 2018/11/30 11:47 by saso_santelj